2
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
CPSMC0100-226
Installation
Installing a Slide-in-Module
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when installing the media converter slide-in-module into the single-slot
chassis. Failure to observe this caution could result in damage or failure of the
media converter slide-in-module.
The maximum power delivery capacity for the CPSMC0100-226 is 6 watts.
To install a slide-in-module into the single-slot chassis:
1. Refer to the user’s guide that comes with the slide-in-module to ensure that any
switches or jumpers on the module’s circuit board are set correctly for the site
installation.
2. Carefully align the slide-in-module to the chassis installation guides and slide the
module into the installation slot.
3. Ensure that the slide-in-module is firmly seated inside the chassis.
4. Push in and rotate the attached panel fastener screw to secure the slide-in-module
to the chassis. See photo below.
Panel Fastener Screw
techsupport@transition.com -- Click the “Transition Now” link for a live Web chat.
3
Power the chassis
CAUTION:
When using two power supplies to power the chassis, one must be a power supply with
an ungrounded secondary. Using two power supplies
(with each secondary grounded
to protective earth ground)
could cause unreliable operation of the chassis and its
converters, due to installation specific Protective Ground fault conditions.
Note:
The first power supply shipped with the chassis has its secondary connected to
protective earth ground. The second power supply does not have its secondary
connected to protective earth. Do Not use two power supplies
(with grounded
secondaries)
to power the chassis.
To supply power to the single-slot chassis using the power supply:
1.
Connect the barrel connector of the power supply
(grounded secondary)
to one of
the single-slot chassis’ power ports
(located on the back of the chassis)
. See
figure below.
2.
Connect the barrel connector of the second power supply
(ungrounded secondary)
to the single-slot chassis’ remaining power port.
3.
Connect the power supply plug(s) into AC power.
4.
Verify that the single-slot chassis is powered by observing the illuminated LED(s)
on the chassis front panel. See the figure below.
Note:
If the power supply/supplies are 11VDC or above, the associated LED/LEDs
will be lit
(PS1 LED/PS2 LED).
If either power supply’s output is under the
11VDC minimum requirement that LED will not turn ON, indicating a
problem.
DC power source
To power the single-slot chassis, using the SPS1872-SA DC external power supply,
consult the SPS1872-SA user manual at Transition Networks.com.
P/ S 1
IN
P/ S 2
IN
P/S 1 LE D
P/S 2 LE D
Chassis Front Panel
Chassis Back Panel
