4
PowerStar™ IV
3. INSTALLATION
To install the PowerStar™ IV:
• Unpack the PowerStar™ IV.
•
Optionally set pin jumpers.
•
Optionally install SIC card.
•
Install PowerStar™ IV in rack or on table.
•
Set Polarity Settings switches.
•
Connect link cable to host.
•
Connect port cable to terminal devices.
•
Connect the PowerStar™ IV to power.
Direction is provided in the pages that follow.
Unpacking the PowerStar™ IV
The PowerStar™ IV packing contents should include the following:
Item
Part Number
PowerStar™ IV
PSIV-2/14-11 OR PSIV-2/14-45
Power Cord
3344, 3347, 3348, 3349, or 3523,
(depending upon power configuration
in country where installed)
User’s Guide
7367
In addition, any of the following optional SICs may be included:
Item
Part Number
Twinax SIC
PS-T-SIC
Fiber SIC
PS-F-SIC
Optionally Setting Pin Jumpers
NOTE: The default factory setting makes pins 3 & 4 active in the RJ-11
connector and pins 4 & 5 active in the RJ-45 connector.
NOTE: Since pin jumpers are located inside the PowerStar IV, the
PowerStar™ IV cover must be removed when setting the pin jumpers.
WARNING: DISCONNECT POWER CORD from PowerStar™ IV
before setting jumper pins. Failure to observe this warning could result
in personal injury or death from electrical shock.
WARNING: AVOID CONTACT WITH POWER SUPPLY during jumper
pin setting. Failure to observe this warning could result in personal
injury from electrical shock caused by capacitive discharge.
CAUTION: Wear a grounding device and observe electrostatic
discharge precautions when setting pin jumpers. Use needle nosed
pliers with insulated handle. Failure to observe this caution could
result in circuit board failure.
To verify or modify the jumper pin settings:
1. Place PowerStar™ IV on table or other stable surface.
2. Using medium Phillips screwdriver, remove three (3) screws
that secure cover to PowerStar™ IV left side, three (3) screws
that secure cover to PowerStar™ IV right side, and three (3)
screws that secure cover to PowerStar™ IV back.
NOTE: Do NOT remove
two (2) screws that
secure power connector.
