Connect Host PSM-8E to One or More Device PSM-8E(s)
To connect fiber cable from host PSM-8E multiplexer to device PSM-8E
multiplexer(s):
1.
Referring to drawings on this page and to site requirements.
determine configuration mode (point-to-point, ring, or collapsed
ring) for network installation.
2.
Set configuration switch at back of EACH
AND EVERY PSM-8E IN NETWORK
EITHER to point to point mode (UP - 2
multiplexer setting) OR to ring mode
(DOWN - 3 or more multiplexer setting).
3.
Locate or build 5250-compliant fiber cable(s) with male two-
stranded TX to RX connectors at both ends. (See page 14.)
4.
Connect male TX and RX cable connectors at one end of cable to
TX and RX female connectors, respectively, on host PSM-8E.
5.
Referring to network configuration, connect male TX
and RX cable connectors at other end of cable to RX
and TX female connectors, respectively, on device
PSM-8E(s) OR at fiber-optic patch panel.
TX
TX
RX
RX
TX
TX
RX
RX
Host Port
Connections
Host Multiplexer
RX
Device
Connections
Device Multiplexer
Fiber-optic
Backbone
Device Multiplexer
Device Multiplexer
Device Multiplexer
Device
Connections
Device
Connections
Device
Connections
Fiber-optic
Patch Panel
TX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
TX
RX
RX
RX
RX
RX
TX
TX
TX
TX
Host Port
Connections
Device
Connections
Host Multiplexer
Device Multiplexer
Fiber-optic
Backbone
TX
TX
RX
RX
Device
Connections
Device Multiplexer
TX
RX
Device
Connections
Device Multiplexer
TX
RX
Fiber-optic
Backbone
Fiber-optic
Backbone
Fiber-optic
Backbone
Host Port
Connections
Device
Connections
Host Multiplexer
Device Multiplexer
Fiber-optic Backbone
TX
TX
RX
RX
POINT TO POINT
(2 MUXES)
RING MODE
(3 OR MORE MUXES)
Point-to-Point Mode
Ring Mode
Collapsed Ring Mode
Summary of Contents for PSM-8E
Page 9: ......
