Transition Networks
SMxxTAT4Xx Install Guide
33785 Rev. B
Page
13
of
43
Power over Ethernet (PoE)
Port Configuration
Supports per port PoE configuration function
PoE Scheduling
Supports per port PoE scheduling to turn on/off the PoE devices (PDs)
Auto-checking
Check the link status of PDs. Reboot PDs if there are no responses
Power Delay
The switch provides power to the PDs based on delay time when PoE switch boots up,
in order to protect switch from misuse of the PDs
Power Management
modes
(SM48TAT2XA-RP
only)
In Redundant mode, only provide Primary Power Supply up to 820W when two power
supply modules are installed. If one power supply crashes, it can still provide enough
power for system operation and also PD’s operation. This is the default.
In Boost mode, provide Primary Power Supply up to 1640W when two power supply
modules are installed. When the applicati
on total PDs’ power use is over 820W, if one
power supply crashes, system will be automatically rebooted due to power loading
influence. After the switch finishes rebooting, it will only provide 820W to PDs.
Device Management System (DMS)
Graphical
Monitoring
⚫
Topology view: Support intuitive way to configure and manage switches and
devices with visual relations
⚫
Floor view: Easily drag and drop PoE devices to help build smart workforces
⚫
Map view: Enhance efficiency to drag and drop devices and view surroundings
on Google Maps
⚫
Display visual chart of network traffic of all devices and monitor every port at
any time from switches
Find my Switch
Helps you locate switches quickly and manage directly
Traffic Monitoring
Display visual chart of network traffic of all devices and monitor every port at any
time from switches
Troubleshooting
⚫
Network diagnostic between master switch and devices
⚫
Provides protection mechanisms, such as rate-limiting to protect your devices
from brute-force downloading