Transition Networks
SMxxTAT4Xx Install Guide
33785 Rev. B
Page
17
of
43
Manual Overview
This manual describes how to install, initially configure, and troubleshoot the switch, including how to:
•
Check switch status by reading the LED behavior,
•
Reset the switch or restore the switch to factory defaults,
•
Install the switch,
•
Use a Web browser or the CLI to initially configure the switch, and
•
Troubleshoot the switch.
Note that this manual provides links to third party web sites for which Transition Networks is not responsible.
Related Information
A printed Quick Start Guide is shipped with each switch.
For Transition Networks Drivers, Firmware, etc. go to the
webpage (logon required).
For Transition Networks Manuals, Brochures, Data Sheets, etc. go to the
(no logon required).
For SFP manuals
see Transition Networks
Other related manuals are listed below.
•
SMxxTAT4Xx Quick Start Guide, 33784
•
SMxxTAT4Xx Install Guide, 33785 (this manual)
•
SMxxTAT4Xx Web User Guide, 33786
•
SMxxTAT4Xx CLI Reference, 33787
•
Release Notes (version specific)
Caution
: The switch is an indoor device. If it is to be used with outdoor devices such as outdoor IP cameras or
outdoor Wi-Fi APs, then you are strongly suggested to install a surge protector or surge suppressor in order to
protect the switch. The switch is compliant with 802.3at in Environment A when using an isolated power supply.
For 802.3at Environment B applications, i.e. building to building, copper to copper endpoint connections:
1
) use
an Ethernet network isolator module (PoE disabled), or
2
) use mid-span injector(s), such as Transition Networks
MIL-L100 or, L1000i-
at, between this switch’s PSE port and link partner PD port.
Warning
: This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment may
cause radio interference.
