reader the user can‘t exit from the controller inside, also, the user can‘t enter in and
exit continuously.
10.5 Anti-Pass Back for 2 doors
See Figure
4 for the Connection Diagram. Door 1 with one DOLCSAW10KH and Door 2 with
one DOLCSAW10KH, set DOLCSAW10KH on Door 1 as the Anti-Pass Back Auxiliary unit (3 2 #),
and set the other DOLCSAW10KH
on Door 2 as the Anti-Pass Back Master unit (3 1 #). Then
they build up a
two doors anti-pass back system, which is normally used for a parking lot…etc
The operation and function is shown below:
5.1 Set the needed function and enroll the User Cards from DOLCSAW10KH Anti-Pass Back
Master unit on Door 2
.
5.2 With the valid user card, the user can only enter in from Door 1, and exit from Door 2. On
the other hand, without entering record from the Auxiliary unit, the user can t exit from the
Master unit or Auxiliary unit, also, the user can t enter in and exit continuously.
10.4 Anti-Pass back for single door (3 1 #)
See Figure 1 for the connection diagram. Install one Wiegand reader (or a DOLCSAW10KH
without user information as reader) outside the door, connecting to one DOLCSAW10KHController
inside the door which acts as the Anti-Pass Back Master unit. Of the two devices, they build
up an anti-pass backsystem for single door. The operation and function is as below:
4.1 Set the needed function and enroll the User Cards on the inside DOLCSAW10KH Anti-
Pass Back Master unit.
4.2 With the valid user card, the user can only enter the door from the outside reader, and exit
from the inside DOLCSAW10KH
Controller. On the other hand, without entering record from the
11
