1800 816 277
www.tti.com.au
18
Product HandBook
GlidePath
™
•
At the pressure regulator manifold, turn the required valve(s) to ON, refer to Figure 5.
•
Turn the operation lever from BYPASS to ON, or if supplied, from the driver’s seat, turn the optional control
solenoid operated switch to ON (Figure 9). The fluid will now start to discharge from the boom spray
nozzles.
•
Commence driving the tow vehicle at the speed determined during calibration to achieve the required
spray outcome.
•
If fitted, at the end of each swath or before turning around, switch the solenoid valve’s switch to OFF. When
commencing the next swath, turn the switch back to ON.
Figure 9 – Remote Control Solenoid Operated ON-OFF Switch Unit
Foam Marker Kit Operation
The Foam Marker Kit, available as an option for the GlidePath, is operated as follows:
•
Connect the electrical cable to a suitable supply on the vehicle, refer to Figure 4.
•
Fill the marker container with a rich soapy water solution such that it achieves a dense foam when ejected
from the nozzle.
•
From the driver’s seat, turn the solenoid valve’s switch from the central OFF position to either the left
or right ON position, refer to Figure 10. The foam will now start to discharge in timed intervals from the
selected nozzle at the end of the boom.
•
Start the spraying operation as described above.
•
Commence driving the tractor at the speed determined during calibration to achieve the required spray
outcome. The foam will mark the edge of the current swath, enabling accurate alignment with the next
swath, ensuring there is minimal overlap and no missed areas.
