1800 816 277
www.tti.com.au
12
Product HandBook
SpotPro
™
SpotPro Operating Instructions
Before first use
Your SpotPro Spray Unit is delivered fully assembled and ready to be fitted onto the vehicle. Before use, it
needs to be set up using the following instructions:
•
Complete the warranty registration online at www.tti.com.au/warranty-registration, or use the Warranty
Registration Card at the back of this handbook.
•
Store this handbook, along with the Tank Quality Check Form and pump unit’s manual in a safe and easily
accessible place for future reference.
WARNING! The operator must fully understand all aspects of this handbook.
Do not operate the SpotPro if you are unfamiliar with its operation until you
have read this handbook.
•
Read and thoroughly understand this handbook, paying particular attention to all safety requirements,
before using the SpotPro for the first time.
•
Check that all fittings, valves and hoses are secure following transit, and are not damaged in any way.
•
Inspect the tank for any damage or abrasions that may occur during transit.
CAUTION! The unit must be securely mounted to the vehicle. Failure to do
so may result in the unit moving or falling off the moving vehicle. Warranty
is conditional on the unit being correctly mounted.
•
Position your SpotPro unit onto the vehicle and mount securely. Tie-down straps can be located into the
tie-down recesses on the SpotPro tank – the 220L tank has one recess, the 400L tank has two. The tie-
down straps must be rated to at least the total mass of the unit when filled with fluid. Alternatively, the
tanks incorporates the Surefit pin mount holes on its base, to enable a bolt and bracket system to secure
the unit to the vehicle. The 400L unit has four Surefit mount points, the 22L unit has two, refer to Figure 4.
Figure 4 – Component Identification – SpotPro Deluxe 200L
•
For the SpotPro Deluxe, the integrated tank frame may be either bolted to the vehicle or secured by tie-
down straps.
