1800 816 277
www.tti.com.au
14
Product HandBook
SpotPro
™
•
Follow the chemical manufacturer’s instructions and safety precautions carefully, taking note of the order
in which the products are added to the tank.
•
Measure the correct quantities of chemicals using clean measuring containers specifically for this purpose
only, then add the chemicals to the tank.
•
Rinse out the measuring containers and any empty containers and pour the all rinsing’s into the SpotPro
tank.
CAUTION! Do not overfill the tank. This may result in chemical spillage.
CAUTION! The SpotPro must never be left unattended while being filled
with fluid.
•
Top up the tank with water to the required level, ensuring it is not overfilled.
•
Thoroughly mix the contents by stirring with a suitable paddle or starting the pump with the pressure
regulator knob turned anti-clockwise to the BYPASS (“0” pressure) position.
•
Upon completion of filling the SpotPro tank, replace the filler cap and twist to tighten.
•
Wash off any spillage from outside the tank.
•
Close the chemical supply containers and store appropriately. Any empty containers must be thoroughly
rinsed and set aside for collection and disposal in compliance with environmental and work safety
requirements.
Operating Instructions
The SpotPro is started and operated as follows, refer to Figure 6:
•
Position the vehicle at a suitable point of the operations area.
•
Confirm the tank contains the required chemical or water quantity.
NOTE! Ensure the pressure regulator is set to the minimum position.
•
At the pump, check that the pressure regulator is set to the minimum position by turning the knob fully
anti-clockwise.
