1800 816 277
www.tti.com.au
15
Product HandBook
SpotPro
™
Figure 6 – Pressure Regulator
•
Check that the optional spray boom valve is in the CLOSED position.
•
Start the pump, refer to Petrol Pump Operation procedure below.
•
Turn the pressure regulator knob clockwise to the required pressure – approximately 3 bar for spray boom
operation, and 5 bar for hose operation. Refer to the calibration procedure described above for the actual
required pressure setting for spray boom operation.
•
For spraying operations, refer to:
•
Spray Boom Operation
•
Hose Spray Operation
Petrol Pump Operation
The SpotPro’s Honda GX35 petrol pump engine is started as follows, refer to Figure 7:
•
Turn the fuel tap to ON.
•
Set the choke lever to the closed position.
CAUTION! Ensure the engine’s throttle is set to idle if the engine is cold. Do
not adjust the throttle to maximum speed until the engine has warmed up.
•
Check that the remote-mounted throttle (located above the suction filter) is set to the idle position. If
restarting a warm engine, the throttle can be left at normal engine operating speed.
•
Grasping the pull-start handle, firmly pull to start the engine. This may need to be repeated 2-3 times. If
the engine fails to start, refer to the supplied pump manual.
