1800 816 277
www.tti.com.au
5
Product HandBook
SpotPro
™
General Safety Instructions
1. This unit is designed and manufactured solely for the purpose of carrying and spraying herbicides and
pesticides. Under no circumstances should it be used for any other purpose. It must never be used for
transporting fuel.
2. Only authorised and trained personnel are to operate this equipment. Operators must have read and fully
understood this manual before operating the SpotPro unit.
3. Do not operate the SpotPro unit anywhere near bystanders, livestock, watercourses or any non-targeted
vegetation that may be in danger from spray drift contamination.
4. Wind direction and speed must be taken into account, as windy conditions may endanger the operator or
damage to adjacent non-target vegetation. Avoid spraying on hot and sunny days or when wind speed
exceeds 6.5km/h.
5. Do not operate this equipment while under the influence of alcohol or any drugs that could impair your
capabilities in any way.
6. Personal Protection Equipment (PPE) must be worn when operating the petrol pump on the SpotPro unit.
Exposure to excessive noise over an extended period can cause impairment or loss of hearing.
7. PPE appropriate to the chemicals being used must be worn at all times when operating the SpotPro.
As a minimum, the PPE should include coveralls, gloves and boots. A face shield and PVC apron are
recommended depending on the task. It is recommended that the following documents should be read
and understood by the operator:
•
Australian Standard for Chemical protective clothing AS3765
•
Australian Standard for Respiratory protection devices AS1715
8. Ensure the capacity of the vehicle is suitable for the loaded mass of the SpotPro. Refer to the vehicle’s
operator manual for safe working loads, correct securing points and relevant safety instructions. Do not
exceed the carrying and braking capacity as specified by the vehicle manufacturer. As a guide, one litre of
water weights one kilogram (kg), therefore a full 400 litre SpotPro will weigh in excess of 490kg.
9. The unit must be securely restrained on the vehicle. Ensure all fasteners are tightened and secure before
operation.
10. Care should be taken at all times, particularly when operating on rough or steep terrain. Drivers should be
aware of fluid surge affecting the vehicle’s centre of gravity.
11. The SpotPro must never be left unattended while being filled with fluids.
12. Do not operate the pump when there is no fluid in the tank.
13. Do not disconnect any hoses, nozzles or filters while the equipment is operating. Disconnecting any
components while under pressure may result in uncontrolled fluid discharge which may be hazardous.
14. At completion of the operation, switch the pump off and relieve any residual pressure by squeezing the
spray gun trigger or opening an optionally fitted spray boom valve.
15. At completion of the operation, decontaminate the SpotPro tank and spray lines. Drain any residue
chemicals and store in a sealed container. Dispose of any unwanted chemicals and tank rinse residue in
accordance with current environmental and workplace health and safety regulations.
16. The SpotPro has safety labels affixed to various locations on the unit. These labels should be kept clean
and legible, and replaced if damaged.
17. Any unauthorised modifications to this equipment may affect its function and create a serious safety risk.
Any unauthorised modifications will void any warranty on the unit.
