1800 816 277
www.tti.com.au
13
Product HandBook
SuperReel
™
•
With the hose pressure released, the hose is ready to stow back onto the SuperReel.
•
To retract the hose, apply a little tension to the hose, to ensure the hose does not flip off the spool upon
starting.
•
Press the button on the remote control supplied with the SuperReel to start retracting the hose, refer to
Figure 5. The hose will wind on to the reel’s spool, guided by the integrated fairlead.
•
Release the button when the hose is retracted, allowing enough slack in the hose to stow the spray gun
in its holder beside the SuperReel.
Figure 5 – SuperReel
Petrol Pump Operation
The SuperReel’s petrol pump engine is started as follows, refer to Figure 6:
•
Turn the ignition switch to ON.
•
Turn the fuel tap to ON.
•
Set the choke lever to the closed position.
NOTE: Ensure the engine’s throttle is set to idle if the engine is cold. Do not adjust
the throttle to maximum speed until the engine has warmed up.
•
Check that the throttle is set to the idle position. If restarting a warm engine, the throttle can be left at
normal engine operating speed.
•
Grasping the pull-start handle, firmly pull to start the engine. This may need to be repeated 2-3 times.
If the engine fails to start, refer to the supplied Honda engine manual.
