Page
148
Program 67-gp-IP : Hunt Group Pilot Number
67-Gp HUNT NO
- - - 0
Gp = Group No. (01-10)
Value for each Item
IP
Value
Default
Item Description
01
00-10
_ _ _
Hunting Group Pilot Number
02
0-9
0 = Common
Hunting Group Ring Method
This program sets Pilot Numbers for Hunting Groups 1 to 10 and their ringing method.
01. Hunting Group Pilot Number
There are 10 Hunt Groups available in the LYNX. Each Hunt Group is assigned a Pilot Number in this
Mode. The pilot number can be any valid unused station number and will have the same number of digits
as the station-numbering scheme used in the system (2, 3 or 4). On the LYNX Hunt group pilots can be
assigned to be rung from Single Digit DISA.
02. Hunting Group Ringing Method
Assign one of 3 ringing methods for each hunting group.
IP
Value
Item Description
67-gp-02
0
Common Ringing
67-gp-02
1
Linear Ringing
67-gp-02
2
Circular Ringing
67-gp-02
4
Common enable CFW
67-gp-02
5
Linear ring enable CFW
67-gp-02
6
Circular ring enable CFW
Once Hunting Ring Type is set here or in Mode 05-06-08 then ringing this pilot number will access the
stations in the group according to the ringing method selected and the order in which they are
programmed in Mode 68 (Day) and Mode 69 (Night). Each Hunt Group can be from 1 to 16 stations.
There are 3 types of Ring available, Common, Linear and Circular.
If
Common Ring
is enabled then calling the pilot number will always ring all available stations in which
they are programmed in Mode 68 or 69.
If
Linear Ring
is enabled then calling the pilot number will always call the first available station in the order
in which they are programmed in Mode 68 or 69.
If
Circular Ring
is enabled then the stations will be called one after the other for each succeeding call
until all have taken a call and then the Ring will revert to the beginning of the Ring assignment and then
repeat the process.
Rules for Call Forward of calls to Hunt group
Intercom calls to the Hunt group will call forward to an extension, but not to a SPD Dial.
DISA call Hunt group only the first extension in Hunt group can make all call forward to SPD dial .
Stations can remove themselves from receiving Hunt calls by using the DND key but this will also prevent
them from receiving direct calls.
It is still possible to call each station in the Hunting group directly by dialling it's own individual station
number.
Summary of Contents for Lynx DK6 Series
