E.
System requirement
Minimum Configuration
Recommended Configuration
- Windows XP
- Pentium 3, 500Mhz
- 256M RAM
- 400MB disk space
- Network speed: 128Kbits/sec
- 3D-capable video card with 16Mbytes of VRAM
- 1024x768, "16-bit High Color" screen
- Windows 7, 8, 10 PC version
- Pentium 4 2.4GHz+ or AMD
- 1G RAM
- 2 GB of free disk space
- Network speed: 768 Kbits/sec or better (DSL/Cable)
- 3D-capable video card with 32 MB of VRAM or greater
- 1280x1024, "32-bit True Color" screen
[Notes and Warning] If you have recorded more than 250,000 way points in your GL-770, it may take the entire resource of
your computer to show all the logged data in Google Earth. Therefore, with not enough RAM capacity the computer may
hang up (system frozen).
F.
Getting Started
Step1. Fully charge the battery via USB port first before starting to use.
Step2. Press and hold Power bottom for 3 seconds to turn on / off the device.
Step3. Acquire GPS signal
Orange LED will start blinking when GPS signal is acquired and have a valid fix.
Step4. Push POI to mark a specific waypoint.
Vibrating/beeping feedback are provided when POI button is pressed
G.
How to extract logged data from GL-770
Step1. Install LogView or Trackshare and USB driver (Download from
“http://www.transystem.com.tw/support.php”)
Step2. Power on GL-770 and connect to PC or laptop.
Step3. Download the data by the software.
To display the track points on Google Earth, your PC must have installed Google Earth and have the
Internet connection. Google Earth installation (Download from http://earth .google.com/)
[Note] Google Earth is a trademark of Google.
H.
Helpful tips
●
Some vehicles using heavy metallic sun protecting coating on windshield may affect GPS signal reception.
●
Streets with high rising buildings may affect GPS signal reception.
●
Tunnel and indoor parking garage may affect signal reception.
●
In general, GPS signal reception best in open space where it can see clear sky. Weather condition will also affect
GPS reception – rain & snow contribute to worse sensitivity.
●
Low battery status may affect signal reception.
●
For the device not in use over several days, allow it 1~3 minutes to obtain satellite constellation information and fix
your position, this is called “Cold Start”. Upon battery replacement, GPS device will do Cold Start again.
●
If your device can not fix position for more than 20 minutes, please change to another location with open space and
then try again.
I.
Certification
GL-770 complies with following regulations.
●
R&TTE Directive 1999/5/EC, Electromagnetic Compatibility Directive 2004/108/EC. (CE)
●
Part 15 of the FCC rules. (FCC), FCC ID: OUP0310GL770
●
ARIB STD-T66 Ver.3.5 (JAPAN RF), MIC ID: 15A0152R - 201-152932/00
FCC Notices
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Change or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate this
equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment.
RF exposure warning. This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating
conditions for satisfying RF exposure compliance."
