Page 9 of 33 – S5 Wireless Microphone Installation Guide Rev 1.2
3. To change the selected channel to a Custom single frequency
This option allows the customer to select 1 of over 1400 available channels.
Press and hold the “Jog-wheel” for approximately 3 seconds if the receiver is
not in mute to enter the
MAIN MENU
. You will enter the
MAIN MENU
immediately if the receiver is in mute.
With
FREQ SELECT
underlined,
press the “Jog-wheel”. With
SINGLE
underlined
press the “Jog-wheel”.
With
EDIT
underlined press the “Jog-
wheel”. The first part of the frequency
will be flashing. Rotate the “Jog-
Wheel” to select this section of a new
frequency and press to accept. The
second part of the frequency will now
start flashing. Change the second part
of the new frequency as above. You
can then change each letter of the
user name in the same way. All ASCII characters are available for the user
name.
If you wish to exit this menu at any time, press and hold the “Jog-Wheel”.
Press the “Jog-Wheel” for 1 second to
exit then rotate till
ACCEPT
is
underlined and press to select the new custom frequency and user name. Go
to the next step to program a transmitter via the receiver infra-red port.
Please note:
For S5.3 product the single user frequency will be added to the transmitter
with receiver Bank1. The S5.3 does not have
USER
bank.
In the case of the S5.5 it will be added to the Custom
USER
bank. You can
download
USER
banks via the Trantec software. Please refer to the software
manual on this CD for more information.
Units for the Japanese market do not have
USER
or
SINGLE
options in the
FREQUENCY
SELECT
menu.
