ENGLISH
45
www.trapp.com.br
Knife Bearing Lubrication Point - TRC-50
Cutting blades
bearing grease
plug
Image merely illustrative
Filling the Tank - TRC-50
Avoid using gasoline that has been stored for more
than seven days as it causes malfunctioning and
decreases the useful life of the engine.
Fill the tank carefully not to spill the fuel.
Use common gasoline only (do not use gasoline
with additives).
Note the capacity of the fuel tank (see “Technical
Specifications”).
Crankcase Oil - TRC-50
The motor leaves the factory without oil, before
starting fill the crankcase with oil as recommended
in the motor manual in regions with atypical
temperature or altitude.
Open the dipstick cap and fill the amount of oil into
the feeder tube, then check the level with the
dipstick.
EXI coconut crushers with EXI engine do not require
oil change, it just must be kept at the correct level as
indicated on the oil dipstick.
Always check the oil level before using the Crusher;
if the level is low, it must be topped up.
Low level
Correct level
Image merely illustrative
If you choose to change the oil, remove the gasoline
from the gas tank, open the oil dipstick cap and tilt
the machine to pour the used oil into an appropriate
container, then follow the manufacturer’s instructions
to dispose of the used oil. After removing the dirty
oil, follow the procedure described above to fill the
crankcase with new oil.
Some motors are factory fitted with a drain plug, in
which case, please see the specification in the motor
manual for oil change.
Warning!
Be careful: Gasoline is highly flammable.
Close the tank, thoroughly tightening
the cover to avoid leakage.
Never fill the tank with the motor on.
Switch the motor off before removing
the fuel cover.
Do not add gasoline while the motor is
hot.
It is recommended to re-lubricate the bearing with 4
grams of grease every 25 working hours.
If the bearing is excessively noisy, contact a TRAPP
Service Technician.
Before injecting the grease by the grease plug, check
the inlet and confirm there is no dirt in the place, thus
improving the lubrication effectiveness
. Clean the
dirt before lubricating.
