ENGLISH
61
www.trapp.com.br
Other models
Mount the grain funnel (1) by attaching it to the green
crop funnel (2) according to the following image, thus,
the dry material crushing work can be performed.
After mounting the funnel, pour the grains intended
to be crushed in the funnel and adjust the material
output opening so as not to overload the motor during
the operation. The material can only be released from
the grain funnel when the motor is in full rotation, as
indicated in page 56.
Turning the motor on with the material inside the
shredder will cause the warranty to be lost.
Image merely illustrative.
Quirera Outlet Pipe Assembly - TRF 400F
Delivered with the fodder crusher TRF 400F:
1 quirera outlet pipe;
4 flat washers Ø 19 x Ø 6,35 x 1,2 mm;
4 spring washers 1/4”;
4 slotted screws UNC 1/4” x 1/2”.
Follow these steps to assemble the quirera outlet
pipe:
Fit the quirera outlet pipe (4) in the body of the
machine;
Insert the flat washer (3), spring washers (2) and
slotted screws (1) as shown below and tight as
necessary.
4
3
1
2
Image merely illustrative.
To Triturate Fodders
Remove the cover plate (1). Except for models
TRF 50, TRF 60 and TRF 70.
Remove the green crop feeder cover (4).
Remove the grain funnel (5).
Place a smooth sieve (2), because the output will be
by the upper part of the shredder. Direct the outlet
spout towards the desired material direction. Except
for models TRF 50, TRF 60 and TRF 70, where the
shredded material will be discharged by the lower
body output and the smooth sieve is not used, the
sieve is simply removed.
The green products are placed into the green crop
feeder (3), and then forwarded to be processed. The
end product leaves the shredder through the upper
part. Except for models TRF 50, TRF 60 and TRF 70,
where the shredded material will be discharged by
the lower body output.
When using grass or sugar cane, do not exceed the
feeding capacity so as not to overload the motor.
Exceeding the feeding capacity may block the
material output spout.
In models TRF 50, TRF 60 and TRF 70, the processed
material leaves through the lower part. Check the
machine position and the direction intended to launch
the material before turning the machine on.
