-13-
VII. a -TROUBLESHOOTING GUIDE
FIND YOUR PROBLEM HERE
REMEDY
1. Condensing unit fails to start.
a.Check if cord & plug has been disconnected.
b.Check control temperature setting.
2. Condensing unit operates for prolonged periods or
continuously.
a.Are doors closing properly?
b.Dirty condenser or filter. Clean properly.
c.Evaporator coil iced. Needs to defrost. See instructions for
setting a manual defrost cycle on section VI.c.
3. Food compartment is too warm.
a.Check door(s) and gasket(s) for proper seal
b.Perhaps a large quantity of warm food has recently been
added or the door was kept open for a long period of time,
in both cases, allow adequate time for the cabinet to recover
its normal operating temperature.
c.Control setting too high, readjust per instructions on section
VI.b.
d.Check that condensing coil is clean.
4. Food compartment is too cold.
a.Perhaps a large quantity of very cold or frozen food has
recently been added. Allow adequate time for the cabinet
to recover its normal operating temperature.
b.Adjust the control to a warmer setting, see section VI.b.
5. Condensation on the exterior surface.
a.Check door alignment and gaskets for proper seal.
b.Condensation on the exterior surface of the unit is perfectly
normal during periods of high humidity.
6. Compressor hums but does not start.
a.Call for service.
7. No power to unit
a.Check if cord & plug has been disconnected.
b.Check power supply breaker.
c. Check ON/OFF switch
VII. TROUBLESHOOTING GUIDE
Summary of Contents for Flex
Page 17: ... 16 NOTES ...
