Project
Quantity
Item #
Model Specified:
CSI Section 11400
TRAULSEN
4401 BLUE MOUND RD.
FT. WORTH, TX 76106
PHONE 1 (800) 825-8220
FAX-MKTG. 1 (817) 624-4302
Website: www.traulsen.com
SECTION
7-2
Specifications
Construction, Hardware and Insulation
Cabinet exterior, including front, one piece sides, louver assembly and drawer faces
are constructed of heavy gauge stainless steel. Cabinet interior is constructed of
stainless steel. Exterior cabinet top, back and bottom are constructed of heavy gauge
aluminized steel. Adjustable 6
"
high stainless steel legs are included.
Drawers are self closing on stainless steel slides. Guaranteed for life, work flow
drawer handle is mounted horizontally over recess in drawer which limits protrusion
from door face into aisleways. Screw on vinyl magnetic drawer gasket assures tight
drawer seal. Both cabinet and drawers contain high density, non-CFC, foamed in
place polyurethane insulation.
Proper Use
Fish or poultry products should be layered in the drawers, one layer of ice, followed
by one layer of product, followed by another layer of ice, etc. The top layer of product
should always be covered with a layer of fresh ice. Fish and poultry should never be
mixed within the same unit. Fresh ice should be added periodically to maintain the
proper ice volume and keep product covered. Product should never be kept in the
drawers overnight, and removed for off hours storage. Special care should be taken
to insure that the weep hole in the bottom of each drawer remains clear of
obstruction to allow for proper drainage (product should not be allowed to rest in
water).
The cabinet should be thoroughly cleaned on a daily basis to prevent the build-up of
odors. Provision of a hose reel or hose connection nearby would be ideal for
cleaning convenience.
Refrigeration System
A top mounted, self-contained, balanced refrigeration system using R-134a
refrigerant is conveniently located behind the one piece louver assembly. It consists
of an air cooled condensing unit and a high humidity gravity coil evaporator, which is
suspended from the ceiling to provide an even, recirculated, cold air drop onto the
stored product. Condensate from the evaporator coil and water from the ice are
collected in drain gutters which run to a drain located in the floor of the cabinet. The
drain is a bell trap type with a
3
⁄
4
"
pipe connection. The unit is equipped with a pitched
floor to facilitate both drainage and cleaning. The normal operating temperature should
be approximately 36
°
F, just right to prevent the ice from melting away too quickly.
For temperature monitoring a digital thermometer is included.
Drawer Pans
Each fish file drawer is supplied with one (1) 16
”
wide by 18-7/8
”
long by 6-1/2
”
deep plastic pan, each pan contains a plastic perforated insert. When the ice melts,
the resulting water drains through the perforated insert at the bottom of the pan into
the drain port of the pan. Water is then channeled through a series of tracks to a
drain located in the pitched interior bottom of the cabinet (a floor drain is required for
excess water removal).
Warranties
The standard warranty includes a five year compressor warranty and a one year
parts and labor warranty on all components and the cabinet. Additional warranties
are available at extra cost.
NOTE: When ordering please specify: Voltage, Hinging, Door Size, Options
and any additional warranties. For fast order entry: Fax 1 (800) 765-8728.
Continued product development may necessitate specification changes
without notice. Part No. TR35804 (revised 7/01)
DIMENSIONAL DATA
RFS126NUT
RFS226NUT
Gross capacity cu. ft.
19.3 (547 cu l)
39.6 (1122 cu l)
Net capacity of drawers cu. ft.
4.5 (127 cu l)
9.0 (255 cu l)
Depth - overall in.
29 (73.6 cm)
29 (73.6 cm)
Depth w/drawer extended in.
45
5
⁄
8
(115.8 cm)
45
5
⁄
8
(115.8 cm)
Length - overall in.
28
(71.1 cm)
52
1
⁄
8
(132.4 cm)
Depth - cabinet only
26 (66.0 cm)
26 (66.0 cm)
Height - overall on 6
"
legs
83
1
⁄
4
(211.5 cm)
83
1
⁄
4
(211.5 cm)
Number of drawers
4
8
ELECTRICAL DATA
Voltage
115/60/1
115/60/1
Feed wires with Ground
3
3
Full load amperes
6.7
6.7
Wattage
1
547
547
Net Wt. lbs.
360 (163 kg)
560 (254 kg)
REFRIGERATION DATA
Refrigerant
R-134a
R-134a
BTU/HR H.P.
2
2220 (
1
⁄
3
HP)
2220 (
1
⁄
3
HP)
NOTES
NOTE: Figures in parentheses reflect metric equivalents.
1= Wattage is determined by listed amps X listed volts X an average run time of
70% for refrigerators and 80% for freezers.
2= Based on a 90 degree F ambient and 20 degree F evaporator.
3= For approximate remote weights deduct 40 lbs. from respective net or gross
weight. For other information on remote models, please refer to spec sheet 1
2-2.
Elevation View
RFS126NUT
Elevation View
RFS226NUT
Section View
All Models
Plan View
RFS126NUT
Plan View
RFS226NUT
Equipped With One NEMA 5-15 P Plug
Full load amps and plug style may vary depending on
electrical options chosen and condensing unit employed.
