Traulsen TU048QC, Owner'S Manual

-4-

V. b-REPLACING THE GASKETS:

To remove the gasket to be replaced, grasp it firmly by 
one corner and pull it out.  Before attempting to install 
a new gasket, both the unit and the gasket itself must 
be at room temperature.  Insert the four corners first by 
using a rubber mallet (or hammer with a block of wood).  
After the corners are properly inserted, work your way 
towards the center from both ends by gently hitting with 
a mallet until the gasket is completely seated in place 
(see figure below for proper gasket placement).

NOTE: 

The gasket may appear too large, but if it is in-

stalled as indicated above it will slip into place.

V. c-CLEANING THE CABINET SURFACES:

  Disconnect  electrical power supply 

before cleaning any parts of the unit.

Exterior stainless steel should be cleaned with warm wa-
ter, mild soap and a soft cloth.  Apply with a dampened 
cloth and wipe in the direction of the metal grain.  

Avoid the use of strong detergents and gritty, abrasive 
cleaners as they may tend to mar and scratch the sur-
face.  Do NOT use cleansers containing chlorine, such 
as bleach, this may promote corrosion of the stainless 
steel.  

Care should also be taken to avoid splashing the unit with 
water, containing chlorinated cleansers, when mopping 
the floor around the unit.  

For stubborn odor or spills, use baking soda and water 
(mixed to a 1 tablespoon baking soda to 1 pint water 
ratio).

A stainless steel polish is recommended for shining of 
unit.

SIDE DOOR PANEL

GASKET ASSEMBLY

VERTICAL GASKET 

RETAINER

VI. a-DOOR:

Your Traulsen Full Size Undercounter Quick Chiller model door 
is field re-hingeable.  If re-hinging is required, please contact our 
in-house service department at 800-825-8220 for instructions.

V. CARE & MAINTENANCE (cont’d)

VI.  DOOR