INSTALLING STRINGS ON STREAMLINE EQUIPPED GUITARS:
Streamline Tuning System equipped guitars use standard, ball-end strings. Only a single allen wrench
(included) is required to change strings. We also recommend that you change the strings in pairs due
to the string clamps.
First, loosen existing string by loosening the Knurled Tuning Knob. This allows you to access the ball-end
cavity of the String Sled. Remove the old string then place the ball end of the new string in the cavity.
Tighten the knurled tuning knob just enough that the ball end will not fall out of the sled. Now on the
endcap loosen and remove the string clamp holding the old strings. Loosen the individual string locker. The
old string can be pulled out and the new string can be fed through the hole in the endcap. Pull the string as
tight as possible. Now tighten the individual string locker. Re-install the string clamp and tighten it. Any
excess string can now be cut o. Tune to pitch.
TUNING:
The knurled tuning knobs on the StreamlineTM tuning system raise and lower the pitch of the strings. They do
not turn indefinitely. If too much resistance is met, the string may need to be re-installed or replaced in order
to allow enough space for the tuning sled to move.
STRINGING AND TUNING STREAMLINE SYSTEMS
STRING SLED
STRING
BALL-END
STRING CLAMP
INDIVIDUAL STRING LOCKERS
KNURKED TUNING KNOBS
