After Sales Support TEL: 1800 623 432 · WEB: www.traveler-service.com/au
25
11. Conformity
This device was tested according to Part 15 of the FCC regulations. This device may be operated
provided that the following two conditions are observed:
This device may not cause any interference.
This device must absorb any interference received, including interference that may cause
undesired operation or operational faults.
This device was tested according to Part 15 of the FCC regulations and it was confirmed that the
device complies with the limit values for class B digital devices. The aim of these limit values is
to provide appropriate protection against adverse sources of interference in domestic residences.
This device generates and uses high frequency energy and can emit this.
If the device is not installed in accordance with these instructions, it may cause considerable
interference for radio transmissions. Some devices may produce interference even if these
instructions are followed.
In the event of radio or television reception being affected by this device – this can be easily
tested by switching the device on and off –try to remedy the fault by taking one or more of the
following steps:
Turning the receiving aerial in another direction or changing its location.
Increasing the distance between the device and the receiver.
Connecting the device and the receiver to two different power circuits.
Contact your dealer or a radio/TV expert.
The device bears the CE mark in compliance with the following European
Guidelines:
2006/95/EC Low Voltage Directive
2004/108/EC EMC Directive
The EC Declaration of Conformity can be requested from the address listed
on the Warranty card.
