Rear Blower Installation Instructions
99000138
Page 2 of 6
17601035 - 8/18/10
© Travis Industries, Inc.
2A Secure the snap disk wires in place following the directions below. Go to step 3.
NOTE:
The wires must be properly secured to prevent the wire from
contacting the firebox and shorting out the blower circuit.
2B (Liberty, Endeavor only) Install the snap disk assembly inside of the heat shield following the directions
below. Secure the snap disk wires in place following the directions below.
Secure the snap disk wires in place following the directions below.
NOTE:
The wires must be properly secured to prevent the wire from
contacting the firebox and shorting out the blower circuit.
Slide the wire clip over the
edge of the strip of metal
between the two knock-outs.
Feed the two snap
disk wires into the
eye of the wire clip.
Then carefully
remove all slack from
the wire, making sure
not to dislodge the
snap disk. Pinch the
eye of the wire clip to
secure the wires.
Wire Clip
Snap Disk
Wires
Hang the snap disk assembly in
the space between the stove
and rear heat shield on the left
side. Bend the legs of the
assembly to ensure a tight fit.
Wire Clip
Feed the two snap
disk wires into the
eye of the wire clip.
Then carefully
remove all slack from
the wire, making sure
not to dislodge the
snap disk. Pinch the
eye of the wire clip to
secure the wires.
Snap Disk Wires