Rear Blower Installation Instructions
99000138
Page 3 of 6
17601035 - 8/18/10
© Travis Industries, Inc.
3. Place the blower near the bottom rear edge of the stove. Attach the quick-connects from the snap disk
assembly to the quick-connects on the blower. Push any slack wire into the blower box. Attach the
blower following the directions below.
Endeavor & Liberty:
Feed the two wires from
the blower through this
hole before attaching the
quick-connects.
All Other Models:
Feed the wires
directly upwards
NOTE
:
Prior to attaching the blower, tuck all excess
wire into the area inside the blower.
The blower attaches to the stove with the three
included screws. Use a 3/8” socket driver or wrench.
HINT
:
Attach the screws to the back of the stove prior to
attaching the blower. This will cut the threads and
ease installation.
Plug the power cord into
a 110 V. outlet after
installing the blower.
NOTE
:
Prior to attaching the
blower, tuck all excess
wire into the area inside
the blower.
a
Attach the quick-connects
leading from the snap disk to the
quick-connects from the blower.
b
c
