Sturbridge Blower
(Part # 99000154)
Page 3 of 4
4/8/04
Travis Industries, Inc.
3
Attach the wiring harness following the directions below (do not plug in the power cord at this time).
Do not plug
the heater in
until
installation is
complete.
Attach the black and white wires
labeled “Blower” to the blower
(orientation does not matter).
11/32" Nutdriver
Remove one of the nuts holding
the blower in place. Insert the
screw through the eyelet on the
green ground wire and replace.
b
c
d
Route the wires labeled “Valve
on/off” and “Solenoid” under
the burner pan to a location
near the gas control valve (they
are for the optional modulating
remote).
a
Attach the two black wires
labeled “Snap Disk” to the
snap disk (orientation does
not matter).
AAAAAAAAAAAAA
AAAAAAAAAAAAA
AAAAAAAAAAAAA
AAAAAAAAAAAAA
AAAAAAAAAAAAA
AAAAAAAAAAAAA
AAAAAAAAAAAAA
AAAAAAAAAAAAA
AAAAAAAAAAAAA
AAAAAAAAAAAAA
f
e
Insert the molex connector on the power cord through the
hole on the blower cover and attach it to the molex
connector on the wiring harness. With the outer black
casing of the power cord 1" through the hole, install the
strain relief. The strain relief is best installed using pliers to
compress the two sides while pushing it into the hole.
Attach the two black wires labeled
“Rheostat” to the rheostat wires
(orientation does not matter).
