GS2 Basic Wall Mount Remote Operation
SKU# 99300695
Page 13 of 18
17602250 - 10/7/22
Travis Industries, Inc.
Synchronize the Transmitter to the Remote Receiver
The transmitter will need to be synchronized to the receiver before the remote will work correctly. Synchronizing
is done in the following two steps below (see illustration below):
a) Press the PRG (Program) button on the receiver (receiver will beep 3 times).
b) Press the “ON” button on the transmitter (receiver will beep 4 times).
NOTE: If power is cut off to the receiver for an extended period, you may need to re-synchronize the remote.
Direct Fireplace Operation
The fireplace may be directly operated from the receiver. The three positions are below (see Figure 4):
ON
– Fireplace burner turns on (regardless of transmitter settings).
OFF
– Fireplace burner turns off (regardless of transmitter settings).
REMOTE
– Fireplace is controlled by the transmitter.
Figure 4
NOTE
: When the receiver switch is turned to ON or OFF, the thermostat and burner on/off operating functions will
not work on the transmitter.
°F
"Beep"
"Beep"
"Beep"
"Beep"
"Beep"
"Beep"
ON
REMOTE
OFF
“Beep”
