GS2/MV Basic Wall Mount Remote Installation
with AC Adapter
SKU# 99300696
Page 7 of 18
17602250 - 10/7/22
Travis Industries, Inc.
Steps Specific to MV Fireplace and Insert Installation
This set of installation instructions shows a summary of the remote installation.
For detailed instructions on the placement of the receiver and other details, refer to the
installation manual included with your appliance.
1. Remove the Brown and Red wires from the back of the on/off switch.
2. Place the remote receiver in the appliance (see appliance manual for placement details). Connect the
Brown and Red wires to the Green and White wires from the receiver (polarity does not matter in this
application).
NOTE:
The Molex connector with the Red and White wires remains empty in this application.
3. Remove the on/off switch from its mounting location. Place the switch blank into this location.
4. Verify the wiring does not contact any hot or moving components. Restore the appliance to the correct
configuration. Install the batteries in the remote and receiver. Synchronize the remote to the receiver
(page 13).
Squeeze tabs in to remove switch
