1 6
Finalizing the Installation
Travis Industries
4 0 1 1 0 2 5
9 3 5 0 8 1 0 4
1
Remove the glass following the directions below.
Warning: The appliance must be completely cool before removing the glass.
Note:
If using an FPX arched face, attach the arch covers after installing the glass.
Insert the included glass latch tool into
the hole on the glass frame latch.
a
b
c
Pull the latch out then up to detach it from
the glass frame.
Hold the glass in
place and repeat
steps "a" and "b"
for the opposite
side latch.
d
Hold the bottom of the
glass while swinging the
top outwards. At
approximately 45° the
glass, with frame, can be
pulled up and away. Set
the glass aside to prevent
damage.
Glass Replacement
Make sure both bottom latches are facing upwards
Position the glass at a 45° angle and lay it on
the two tabs below the firebox. When
correctly positioned, the tabs on the frame
should insert into the bottom latches.
Swing the glass into place (make sure the bottom latches
are engaged.
Re-attach the top latches (see steps "a" and "b" above).
Glass
Glass Frame
Glass
Frame
Latch
Glass Latch Tool
NOTE:
A hole is provided here
to store the glass latch
tool.
Summary of Contents for DVL Insert
Page 2: ......
