2 6
Maintenance
Travis Industries
4 0 1 1 0 2 5
9 3 5 0 8 1 0 4
How this Heater Works
!
This heater was designed with safety as the primary concern. Many of the components inside this
heater are for safety purposes. Therefore, only certified gas service technicians should service this
heater.
What Turns the Main Burners On and Off
This heater uses a millivolt system to control its operation (a millivolt is a very small amount of
electricity). The thermopile and thermocouple generate electricity when heated by the pilot flame.
This electricity is used to operate the gas valve. Without enough electricity, the gas valve will not turn
on. That is why when starting the pilot the gas control knob has to be pressed in long enough for the
thermocouple to heat up and generate enough electricity. The thermopile provides power for the
ON/OFF switch, remote control, or thermostat (see the illustration below). Because the thermopile
generates the electricity needed to turn the heater on and off, this heater can be operated when the
power is out (although the blower will not run).
When heated, the thermopile
generates electricity (a very small
amount measured in "Millivolts").
This electricity is
used to operate the
main burners.
The main burners
are switched on and
off using the
electricity generated
by the thermopile.
The ON/OFF switch,
remote control, or
thermostat control
the circuit to the main
burner.
ON
OFF
MAIN BURNER
What Prevents Gas Buildup
+
This appliance utilizes a high-technology gas valve in conjunction with a pilot flame to ensure no gas
builds up inside the firebox.
+
The thermocouple (next to the pilot) senses when the pilot flame is lit. If the pilot flame goes out, this
thermocouple no longer generates electricity, causing the gas valve to automatically shut off all gas to
the heater, preventing the pilot from spilling gas into the firebox.
Ceramic Glass
The glass in your heater is the most
durable glass available. It has been
tested to be extremely resistant to
breakage from temperature changes.
Gas Valve
This high-technology valve automatically
shuts off all gas if it does not receive a signal
from the thermocouple. If any component is
damaged or sensing a malfunction, or if the
wiring is damaged, it will shut off all gas.
Pilot Flame
The pilot flame is a time-proven
component that eliminates the possibility
of gas buildup inside the firebox.
Thermocouple
The thermocouple generates a small
amount of electricity. If the pilot flame
goes out, the gas valve automatically
shuts off all gas.
External Shut Off Valve
This valve is placed on the gas line
to shut off gas to the appliance
during maintenance procedures.
Summary of Contents for DVL Insert
Page 2: ......
