4. Device general overview
1. LED indicators display
2. Red crocodile clip: po
3. Black crocodile clip: negative –
4. Positive end (+)
5. Negative end (–)
6. USB port output for recharging external devices
7. Micro USB port input for recharging power bank device
8. Charging level Blue LED indicators for power bank
9. Power button for power bank
10. LED torch
5. How to use the device
How to jump start the vehicle
1. Make sure the device is charged to at least 75%
2. Connect the clamps cable to the device making sure the “po” (4) and
2.
“negative –“ (5) ends are inserted correctly
3. Once connected, both Green and Red LED indicators (1) on the clamps cable
2.
will flash
4. Open the bonnet of the vehicle
5. Using the clamps cable attach Red crocodile clip (2) to the 'po' and
2.
Black crocodile clip (3) to the 'negative –' of the vehicle battery
6. Once connected, turn On the engine by switching the vehicle starting
2.
system
7. After the vehicle has been started, the LED indicator on clamps cable (1) will
2.
flash Red and will make a buzzer sound
8. Unclip clamps cable from the vehicle battery within 15 seconds
9. If the vehicle requires another jump start, please unclip the clamps cable
2.
from the vehicle battery for 5 sec. and then repeat steps from point 2 to 8
Attention please:
jump starter function is suitable for DC 12V vehicles up to
3 liters engine petrol and up to 2,2 liters engine diesel.
How to charge the power bank
1. Connect the micro USB end of the charging cable to the device (7), and the
2.
USB end to the AC charger
2. The Blue LED power indicators (8) will light up when the device is under
2.
charging
3. When the Blue LED power indicators (8) are solid On then the device is fully
2.
charged
4. Remove the charging cable when finished
How to charge external devices
1. Connect your external device to the USB port (6) of power bank
2. Press the Power button (9) to tum On the power bank
3. The power bank will start charging your external device
4. Remove the charging cable from the external device when finished
How to use the built-in torch
1. Hold down the Power button (9) until the LED torch (10) turns On
2. Once the LED torch is On, repeat to make the light flashing
3. Repeat to turn Off the LED torch
