7
SPECIFIC SAFETY RULES
1. Keep hands away from rotating disc
area at all times!
2. Prolonged breathing of airborne dust
from grinding operations may effect
respiratory function:
Always use a vacuum cleaner with a
bag approved for fine dust installed.
Always wear a respirator approved for
dust and mist.
3. G r i n d i n g L E A D - B A S E D p a i n t i s
extremely toxic and should not be
attempted.
Only allow professionals
with special training and equipment
perform this task.
4. Maintain proper footing and balance
at all times.
Do not overreach.
5. Always wear appropriate safety
equipment when operating.
6. Important: After completing operation,
switch off the switch and wait for the
coasting disc to stop completely
before putting the tool down.
7. Never operate
the tool in an area with
flammable solids, liquids, or gases.
Sparks from the commutator/carbon
brushes could cause a fire or explosion.
8. There are certain applications for
which this tool was designed.
The
manufacturer strongly recommends
that this tool NOT be modified and/or
used for any application other than for
which it was designed. If you have any
questions relative to its application DO
NOT use the tool until you have written
the manufacturer and have been
advised.
9. Use the machine with both hands at all
times.
Loss of control can cause
personal injury.
10. Keep power supply cord clear from the
working range of the machine.
Always
lead the cable away behind you.
11. Immediately switch off the machine if
u n u s u a l v i b r a t i o n s o r i f o t h e r
m a l f u n c t i o n s o c c u r .
C h e c k t h e
machine in order to find out the cause.
12. The dust that arises when working with
this tool can be harmful to health.
Use
a dust absorption system and wear a
suitable dust protection mask and
remove deposited dust with a vacuum
cleaner.
■
FUNCTIONAL DESCRIPTION
This Stone Grinder is designed for finish
grinding of stone. Various grits of hook &
loop backed diamond polishing pads are
available for this purpose..
■
Electrical connection
The network voltage must conform to the
voltage indicated on the tool name plate.
Under no circumstances should the tool be
used when the power supply cable is
damaged.
A damaged cable must be replaced
immediately by a qualified Customer
Service Center. Do not try to repair the
damaged cable yourself. The use of
damaged power cables can lead to an
electric shock.
