Revo 3.3
•
15
TQ 2.4GHZ BINDING INSTRUCTIONS
For proper operation, the transmitter and receiver must be
electronically ‘bound.’
This has been done for you at the factory.
Should you ever need to re-bind the system, follow these
instructions.
Note
: the receiver must be connected to a 4.8-7.2v
power source for binding.
1.
Press and hold the transmitter’s SET button as you switch
transmitter on. The SET LED will flash.
2.
Press and hold the receiver’s LINK button as you switch receiver
on. The LINK LED will flash.
3.
When both LEDs stop flashing (this will take just a moment or
two), the system is bound and ready for use. Confirm that the
steering and throttle operate properly before driving your model.
TQ 2.4GHZ FAIL-SAFE OPERATION
When bound to the transmitter, the 2.4GHz Micro Receiver
automatically sets its fail-safe position to throttle neutral. This
means the receiver will automatically return the throttle setting to
neutral in the event of signal loss due to interference, low battery
power, or accidentally switching the transmitter off while driving.
When powered on, the receiver’s green LED will glow to indicate
fail-safe mode is active. If the LED glows red, the fail-safe mode has
been deactivated. Use these steps to reactivate the fail-safe system:
1.
Switch the transmitter and receiver on.
2.
Press and hold the receiver’s LINK button. The LED will flash once,
then turn off. Continue to hold the LINK button. After about three
seconds, the LED will flash on and off. It will continue flashing as
long as you hold the LINK button.
3.
Release the LINK button. The LED will now turn green and glow
steadily, indicating fail-safe mode is active.
SETTING THE RECEIVER THROTTLE NEUTRAL
The Traxxas TQ 2.4GHz radio system is pre-set at the factory and is
ready for use.
If you wish to reprogram the receiver to make certain
the throttle neutral is correctly set, follow the steps below.
1.
Switch the transmitter and receiver on.
2.
Press and hold the receiver’s LINK button until the LED blinks red
once then switches off. Release the LINK button.
3.
Pull the throttle trigger to the full-throttle position and hold until
the receiver’s LED blinks red twice.
4.
Push the trigger to full brake and hold until the red LED blinks twice.
5.
Return the trigger to neutral. The LED will blink three times then
remain on (the LED will glow green if fail-safe is active, or red if
fail-safe is disabled).
Don’t attempt to operate
your Revo if there are any
problems with your radio
system or radio interference
at your location.
THE TRAXXAS TQ 2.4GHZ RADIO SYSTEM
