Traxxas Revo 3.3 5309 Owner'S Manual Download

Page: 24 / 44

•

Revo 3.3

The Traxxas EZ-Start brings the convenience of push-button electric
engine starting to your Revo. The EZ-Start consists of a hand-held control
unit and an on-board motorized starter.

Power for the EZ-Start system comes from a 7.2-volt rechargeable battery

pack installed in the hand-held control unit.

The engine glow plug is heated automatically by the EZ-Start system,

eliminating the need to keep up with a separate glow plug igniter.

The voltage to the glow plug is kept constant, regardless of the

load placed on the starter by the starter motor.

The “Glow Plug” LED (light emitting diode) on the control unit

indicates the condition of the glow plug.

The “Motor” LED indicates the status of the EZ-Start electric starter motor.
The cush drive mechanism in the drive unit prevents damage to the

gears caused by engine kickback.

Smart Start

™

protection circuitry prevents damage to the motor by cutting

power if the load on the motor or other electronics exceeds safe limits.

Charging the EZ-Start Battery

The included charger can be used to charge the included EZ-Start
battery pack.

Plug the charger into the wall. The LED on the charger should

glow green.

Connect the included EZ-Start battery pack to the charger output

cord. The LED will glow red indicating the battery is charging.

The battery should charge for approximately 4

hours. The LED

will turn green when the battery is fully charged.

Installing the EZ-Start Battery
1.

Press the tab in the end of the battery

compartment door to open (A).

Plug a fully charged 7.2-

volt battery pack into the
connector inside (B).

Twist the battery two or

three times to twirl the
battery plug wires. This
helps hold the wire and
battery in place when the
battery is installed in the
compartment (C).

Install the battery into the

compartment and press the wires securely into place.

Snap the battery compartment door back on and lock the

end tab (D).

Using the EZ-Start

Your EZ-Start controller plugs into a 4-prong receptacle in the center of the
bed on your Revo 3.3. When the red button on the controller is pressed,
the EZ-Start motor begins to spin the engine and power from the control
unit heats the glow plug. Assuming all settings and preparations are
correct, the engine should start almost immediately.

Each of the two status indicator LEDs on the hand-
held control unit, the

Motor

LED and the

Glow Plug

LED, should light green while starting. If either LED
fails to light while starting, there is a fault indicated
with that function.

If the Glow Plug LED fails to light, the glow plug may
be bad, or the glow plug wire may be damaged or
disconnected.

If the Motor LED fails to light and the starter fails to
operate, then the EZ-Start is in protection mode.

Using Other Chargers

Another convenient option
for charging the included
battery is an AC peak-
detecting charger that
plugs directly into an AC
wall outlet, such as the
TRX Power Charger, Part
#3030X. It contains special
peak-detection circuitry
that automatically shuts the
charger off when the battery
is fully charged.

Caution

: Never use a

15-minute timed charger to
recharge your model’s battery
packs. Overcharging may
result, causing damage to the
battery packs.

THE TRAXXAS EZ-START ELECTRIC STARTING SYSTEM

Motor

Glow Plug

Motor

Glow Plug

Motor

Glow Plug

Motor

Glow Plug