Revo • 25
The TRX 2.5R Racing Engine
throttle is increased, the low-speed needle is pulled completely away
from the needle seat leaving it fully open. At that point, fuel metering is
entirely controlled by the high-speed needle. Again, using our water
hose example, when the spray nozzle at the end of our garden hose is
fully open, then the main water valve can be used to adjust how fast the
water flows.
The engine’s performance is directly linked to the fuel mixture.
Richening the fuel mixture increases the amount of fuel in the air/fuel
mixture ratio and leaning the fuel mixture decreases the amount of
fuel in the air/fuel mixture ratio.
Slightly lean fuel mixtures deliver stronger, more efficient
combustion and more power, but with less lubrication.
Slightly rich fuel mixtures deliver cooler running and more
lubrication but with slightly less power.
Tuning the engine means finding the perfect balance between the two;
excellent power to meet your needs while maintaining good lubrication
for long engine life.
The optimal fuel mixture setting is rich
to provide a
safety margin against having a lean condition if some variable changes
(such as the temperature from one day to the next).
General fuel mixture settings are measured by the number of turns the
needles are turned out from fully closed. The fuel mixture settings have
been pre-set from the factory to typical break-in settings. Do not
readjust your carburetor from the factory settings until after the engine
is started and running, and you have been able to observe the engine
running to assess what minor adjustments may be required to
compensate for fuel, temperature, and altitude. Adjustments are usually
made in 1/8 or 1/16-turn increments.
The Idle Speed Adjustment
The idle speed screw controls the closed position of the throttle slide.
When the throttle servo is in its neutral position, the throttle slide should
be stopped against the idle adjustment screw. Always use the idle speed
adjusting screw to control engine idle. Do not use the throttle trim on
the transmitter to adjust idle speed. The idle speed should be set as low
as possible and still maintain reliable running.
Water Valve
(Controls Overall Flow)
High Speed Needle
Water Nozzle
(Controls Fine Flow)
Low Speed Needle
Richen
Lean
Rich
See
Tuning Your TRX 2.5R
Racing Engine
on page 30
for complete information on
adjusting the air/fuel
mixture and idle speed.
Factory Needle Settings
If your factory preset
carburetor adjustments
have been tampered with,
use the following settings:
• Set the high-speed needle
to 4 turns out from closed.
• Set the low-speed needle
so the screw head (
red in
Fig. A
) is flush (even) with
the end of the slide (
yellow
in Fig. A
).
Always use the factory
settings for initial starting.
Only use these settings
when the factory settings
have been lost.
Low Speed
Needle Adjustment
Fig. A
