SLASH • 11
THE TRAXXAS TQ RADIO SYSTEM
INSTALLING TRANSMITTER BATTERIES
Your TQ transmitter uses 8 AA batteries. The battery compartment is
located in the base of the transmitter.
1. Remove the battery compartment door by pressing the tab and
lifting the door up.
2. Install the batteries in the correct orientation as indicated in the
battery compartment.
3. Reinstall the battery door and
snap it closed.
4. Turn on the transmitter and
check the power indicator for
a solid red light.
If the power indicator light flashes, then the transmitter batteries are
weak, discharged or possibly installed incorrectly. Replace with new or
freshly charged batteries. The power indicator light does not indicate
the charge level of the battery pack installed in the model.
The Traxxas High Current Connector
Your model is equipped with the Traxxas High-
Current Connector. Standard connectors restrict
current flow and are not capable of delivering
the power needed to maximize the output of
the XL-5. The Traxxas connector’s gold-plated terminals with a large
contact surfaces ensure positive current flow with the least amount of
resistance. Secure, long-lasting, and easy to grip, the Traxxas connector
is engineered to extract all the power your battery has to give.
INSTALLING THE BATTERY PACK
Your model requires a fully
charged NiMH 7.2V to 8.4V
6 or 7-cell battery pack
with Traxxas High-Current
Connector. Install the battery
pack with the battery wires
facing the rear of the model.
Insert the tabs of the battery
hold-down into the slots in
the rear hold-down retainer
and then place the battery
hold-down over the post.
Secure the battery hold-
down with body clip in the
hole in the post. Do not connect the battery pack yet.
Using Different Battery Configuration
The battery hold-downs are capable of accommodating either side-by-
side racing style packs or the more common stick packs. The battery
compartments are configured for stick packs from the factory. The
number on each side of the hold down indicates the battery height
in millimeters that hold-down can accommodate. Note that one side
is labeled “25” and other side is labeled “23”. The 25mm side is for use
with typical stick type battery packs. If you are using side-by-side racing
packs, simply flip the hold-down over to the 23mm side and use it on
the opposite side of the chassis. Your model includes a foam block
which should be installed in front of 6-cell batteries for a more secure fit.
CH.2
CH.1
Use the Right
Transmitter Batteries
Your transmitter uses AA
batteries. Use new alkaline
batteries, or rechargeable
batteries such as NiCad or
NiMH (Nickel Metal Hydride)
batteries in your transmitter.
Make sure rechargeable
batteries are fully
charged according to the
manufacturer’s instructions.
If you use rechargeable
batteries in your
transmitter, be aware
that when they begin
to lose their charge, they lose
power more quickly than
regular alkaline batteries.
Caution: Discontinue running
your model at the first sign of
weak batteries (flashing red
light) to avoid losing control.
If the power indicator
doesn’t light red, check the
polarity of the batteries.
Check rechargeable
batteries for a full charge.
25mm side: Standard
NiMH stick pack setup
23mm side: Side-by-side
NiMH pack setup
3,4
