SLASH
•
11
INSTALLING TRANSMITTER BATTERIES
Your TQ 2.4GHz transmitter uses 4 AA batteries. The battery
compartment is located in the base of the transmitter.
1. Remove the battery compartment door by pressing the tab and
lifting the door up.
2. Install the batteries in the correct orientation, as indicated in the
battery compartment.
3. Reinstall the battery compartment door
and snap it closed.
4. Turn on the transmitter and check the
status LED for a solid green light.
If the status LED flashes red, the transmitter batteries may be weak,
discharged, or possibly installed incorrectly. Replace with new or
freshly charged batteries. The status LED does not indicate the
charge level of the battery pack installed in the model. Refer to the
Troubleshooting section on page 15 for more information on the
transmitter’s status LED codes.
CHARGING THE BATTERY PACK
The included charger can be used to charge the included battery pack.
The battery pack should be removed from the vehicle before charging.
Do not leave the battery unattended while charging.
It is normal for
the battery to become slightly warm as it nears full-charge, but
the battery should never become hot. If the battery becomes hot,
disconnect it from the charger immediately.
1. Plug the charger into the wall. The LED on the charger should
glow green.
2. Connect the included battery pack to the charger output cord. The
LED will glow red indicating the battery is charging.
3. The battery should charge for approximately 8 ½ hours. The LED
will turn green when the battery is fully charged. Disconnect the
battery from the charger after charging.
2
3
1
Using Other Chargers
Another convenient option for charging the included battery
is an AC peak-detecting charger that plugs directly into an AC
wall outlet, such as the TRX EZ-Peak
™
(Part #2930). It contains
special peak-detection circuitry that automatically shuts the
charger off when the battery is fully charged.
For faster charging, the included battery may be charged at
4 amps. The TRX EZ-Peak
™
is a 4 amp charger and will charge
the included battery in about 45 minutes!
Caution: Never use a 15-minute timed charger to recharge
your model’s battery packs. Overcharging may result, causing
damage to the battery packs.
2,4
If the status LED doesn’t light
green, check the polarity
of the batteries. Check
rechargeable batteries for
a full charge. If you see any
other flashing signal from the
LED, refer to the chart on page
15 to identify the code.
Use the Right Batteries
Your transmitter uses AA
batteries. Use new alkaline
batteries or rechargeable
batteries, such as NiMH
(nickel-metal hydride)
batteries, in your transmitter.
Make sure rechargeable
batteries are fully
charged according to the
manufacturer’s instructions.
If you use rechargeable
batteries in your
transmitter, be aware
that when they begin
to lose their charge, they lose
power more quickly than
regular alkaline batteries.
Caution: Discontinue running
your model at the first sign of
weak batteries (flashing red
light) to avoid losing control.
TRAXXAS TQ 2.4GHz RADIO SYSTEM
