12 • SPARTAN
INSTALLING THE BATTERY PACK
Spartan uses hook-and-
loop straps to secure the
batteries. To install the
batteries, simply loosen
the straps, slide the battery
pack beneath them, and
tighten the straps to
hold the batteries snugly
against the battery tray’s
foam pads. They should be
tight enough to prevent
the batteries from sliding,
but should not be pulled
excessively tight. If you
wish to use other positions in the battery tray, simply remove the
straps and reinstall them in the additional channels provided.
Assemble the straps as shown in the illustration.
Positioning the Battery Packs
• Battery Packs Forward:
This is the standard battery position for
Spartan. Placing the battery packs at the front of the battery trays will
give Spartan the greatest stability in all water and wind conditions.
Whether you are using the included Power Cell 7-cell batteries or
aftermarket NiMH or LiPo packs, always begin with the batteries in
the forward position.
• Battery Packs Centered:
Smooth water and calm winds may allow
you to move the battery packs rearward in the hull to allow the
bow to ride higher and increase Spartan’s speed. Be aware that
positioning the batteries farther aft increases the likelihood of the
boat blowing over at speed or becoming unstable.
• Battery Packs Aft:
Positioning the batteries all the way back in their
trays may provide higher top speeds but will also make Spartan
more prone to blowing over, spinouts, and instability. Experiment
with this position only in very calm conditions, and closely monitor
the hull’s attitude as you increase speed.
3
TRAXXAS TQ 2.4GHz RADIO & VELINEON POWER SYSTEM
