TELLURIDE • 19
RECEIVER BOX:
MAINTAINING A WATERTIGHT SEAL
Removing and Installing Radio Gear
The unique design of the receiver box allows the removal and
installation of the receiver without losing the ability to maintain a
watertight seal in the box. The patent-pending wire clamp feature
gives you the ability to also install aftermarket radio systems and
maintain the watertight features of the receiver box.
Removing the Receiver
1. Remove the wire clamp by removing the two 2.5x8mm cap screws.
2. Remove the cover by removing the two 3x10mm cap screws.
3. To remove the receiver from the box, simply lift it out and set to
the side. The antenna wire is still inside the clamp area and cannot
be removed yet.
4. Unplug the servo cables from the receiver and remove
the receiver.
Receiver Installation
1. Install the electronic speed control (ESC), servo, and antenna
wiring through the receiver box top (A).
2. Plug the ESC and servo wires into the receiver (
see page 10
).
3. Bundle wiring as necessary.
4. Make sure the O-ring is properly seated into
the groove in the receiver box bottom so
that the cover will not pinch it or damage it
in any way.
5. Place the receiver box top onto the receiver
box bottom and install and tighten the two
3x10mm cap screws securely.
6. Inspect the cover to make sure that the
O-ring seal is not visible.
7. Arrange the wires neatly using the wire
guides on the receiver box top (B). Excess
ESC and servo wiring should be bundled
inside the receiver box. Pull out all available
antenna wiring from the receiver box.
8. Apply a small bead of silicone grease to the
foam on the wire clamp (C).
9. Install the wire clamp and tighten the two
2.5x8mm cap screws securely (D).
SETTING UP THE ANTENNA
The receiver antenna has been set
up and installed from the factory.
The antenna is secured by a 3x4mm
set screw. To remove the antenna
tube, simply remove the set screw
with the included 1.5mm wrench.
When reinstalling the antenna,
first slide the antenna wire into the
bottom of the antenna tube until
the white tip of the antenna is at
the top of the tube under the black
cap. Next insert the antenna tube
into the mount while making sure
that antenna wire is in the slot in
the antenna mount, then install the
set screw next to the antenna tube.
Use the supplied 1.5mm wrench
to tighten the screw just until the
antenna tube is securely in place.
Do not over tighten.
Do not bend or kink the antenna wire! See the
sidebar for more information. Do not shorten the antenna tube.
DRIVING YOUR MODEL
A
B
C
D
To prevent loss of radio range,
do not kink or cut the black wire,
do not bend or cut the metal tip,
and do not bend or cut the white
wire at the end of the metal tip.
Correct
No
No
No
No
Antenna
Mount
Antenna
Tip
Antenna
Tube
