Setup and Connection
13
Note: Verify that the control head seal is not pinched and not visible. If a pinch is
found, disassemble the control head, reseat the seal and reassemble the
control head.
3.1.2
Installing and Connecting the Radio
Now install your MOTOTRBO radio into the A100 gateway and connect it to all
required components inside the unit.
1.
Remove the screws and lift the top cover of the unit.
2.
Insert the radio into the slot on the front panel of the unit, orienting the
radio’s back panel inside the unit. Use the screws of the proper size to secure
the radio in the unit.
Figure 4: Installing a MOTOTRBO radio into the unit
3.
Perform the following connections:
a.
Connect the radio to the IP controller with a service cable. The service
cable is included in the package contents.
b.
Connect the radio to the power supply. The black-and-red power cable is
already connected to the integrated power supply unit.
c.
Connect the RF antenna to the mobile radio. The antenna cable is
included in the package contents.
4.
Reinstall the top cover and secure it with the screws.
