ones
tens
hundreds
ones
tens
hundreds
thousands
Setting The Receiver’s Dip Switches
YOU DO NOT NEED TO CHANGE ANYTHING TO MAKE YOUR UNITS
OPERATE!
The units come from the factory set on Group Code 1, Receiver
# 1. If you change the dipswitches, you must reprogram you transmitter to
the same settings, as explained on the previous page.
Should you be using multiple receivers in close proximity to each other, or if
you are getting interference from someone else’s remote, you may need to
change your Group Code # or Receiver # dipswitch settings to prevent
unwanted interference as follows:
To Change the Receiver #:
Remove the four phillips head screws and
separate the Receiver case to expose the Receiver number dipswitch set.
Look on the back of the Receiver board; you will see three boxes of
dipswitches as shown in the photo (Example 1). The dipswitches are ex-
posed on the circuit board on Permanent Receiver Cards (Example 2).The
Receiver # switch set is the box on the far right.
The switches are read
from right to left
, (see below) and are grouped in sets of four. Adding the
numbers of the depressed switches together in each set of four will give
you the total for that digit.
To Change the Group Code #:
The Group Code switch set is the middle
and left-hand boxes.
These switches also read from right to left
,
starting with the middle box and working toward the left (see below) and
are also grouped in sets of four. Adding the numbers of the depressed
switches together in each set of four will give you the total for that digit.
14
800-275-8558 www.remotecontroltech.com
EXAMPLE 1:
Factory Default - Universal Receiver shown
Group Code Switch Set is switched to
Group Code #1
,
Receiver Switch Set is switched to
Receiver #1
Group Code Switch Set Receiver # Switch Set
Group Code Switch Set Receiver # Switch Set
Group Code Switch Set Receiver # Switch Set
Group Code Switch Set Receiver # Switch Set
EXAMPLE 2:
Factory Default - Permanent Receiver Card shown
Group Code Switch Set is switched to
Group Code #1
,
Receiver Switch Set is switched to
Receiver #1
EXAMPLE 3:
Permanent Receiver Card shown
Group Code Switch Set is switched to
Group Code #1
,
Receiver Switch Set is switched to
Receiver #2
EXAMPLE 4:
Permanent Receiver Card shown
Group Code Switch Set is switched to
Group Code #2
,
Receiver Switch Set is switched to
Receiver #3
15
800-275-8558 www.remotecontroltech.com
