TreadTracker PFTK001, Instruction Manual

(c) Rotation Wheel

•  The Rotation Wheel helps to prevent the sensor from toppling over which  

  can happen if TreadTracker is not pointing in the same direction as the  

 treadmill. 

Model No.: PFTK001 

4

1. USB port

2. Jack Input

3. Security Bar

4. Main Wheel

5. Release Button

6. Charging Light

7. Bluetooth Light

8. Arm

9. Power Switch

10. Rotation wheel  

0

(Micro USB cable x 1)  

1. Installation

(a) Placing the sensor

WARNING: 

Before placing TreadTracker in position, ensure treadmill track is not moving.

Place TreadTracker on the floor directly underneath mid-section of the 

treadmill where the TreadTracker Main Wheel       can clearly access the 

treadmill track underside. 

IMPORTANT: 

Ensure the Main Wheel       is only in contact with the tread 

and is not too close to the treadmill frame or the front or rear of the treadmill.

IMPORTANT: 

Ensure the TreadTracker is placed in the same direction as 

the treadmill track which means it's not at an angle.

(Sensor x 1) 

(b) Releasing arm and adjusting for height

Once in position, press the Release Button     . This will cause the Main 

Wheel      to swing upwards and make contact with the treadmill track. The 

Arm      should not have to swing to its maximum height for the Main Wheel      

to make contact.      

If more height is required

•   Pull the Main Wheel       block to extend the Arm until the Release Button clicks.
•   To restore Arm length, simply press the Release Button      and shorten  

  the Arm length holding the Main Wheel     .    

Awesome! 

You've got the TreadTracker. It's going to make your digital running 

experience even better. While it’s kind of obvious how the sensor works do read 

this quick guide so you get the best out of it.  

TREADTRACKER