• When the Power Switch is turned off, the Rotation Wheel is locked.
When the Power Switch is turned on, the Rotation Wheel is free to
pivot side to side.
• Always try to place TreadTracker in same direction
as the treadmill while keeping the Rotation Wheel
in the middle position. If TreadTracker is not
quite in the same direction, the Rotation
Wheel will provide correction for the error.
2. Power Source and Charging
(a) External power source
To connect TreadTracker to a power source, insert the micro-USB cable into
the TreadTracker USB port and plug the USB into a laptop computer or
similar. Charging from the a wall socket may also be done by connecting the
USB cable to a laptop or standard USB plug (input 110-240V, output is 5V, 1A)
such as an iPad plug or iPhone plug.
WARNING:
Ensure USB cable does not get trapped by treadmill frame.
(b) INTERNAL BATTERY
• TreadTracker comes with an internal battery so it can function without an
external power source. When TreadTracker is connected to an external
power source, the internal battery is automatically recharged.
• Battery light will glow red if 10% or less; orange if less than 50% and green
if above 50%
• If plugged in, the battery light will glow. If not plugged in, the
battery will only glow for a few seconds when turned on.
3. Turning TreadTracker On and Off
• TreadTracker can be turned on via the Power Switch located on the underside.
• If TreadTracker is plugged into an external power source it will go into
hibernation (sleep mode) once the Main Wheel has not moved for at least
3 hours.
• If TreadTracker is using the internal battery source it will go into hibernation
(sleep mode) once the Main Wheel has not moved for at least 10 minutes.
• To reactivate (wake up) TreadTracker from hibernation, the Main Wheel
should be rotated for at least 3 seconds.
• To fully switch off TreadTracker, turn the Power Switch located on the
underside to off while ensuring Rotation Wheel is in central position.
4. Connecting TreadTracker to App
(a) Connect using Bluetooth.
• If TreadTracker Bluetooth Light is not on, then TreadTracker is either in
hibernation or switched off (see Section 3)
• If Bluetooth Light is glowing a constant blue it means TreadTracker is
connected.
• If Bluetooth Light is flashing blue it means TreadTracker is seeking to
connect. In the RunSocial App, select the "TreadTracker" option. This will
show a list of available TreadTracker signals. Click on signal to connect.
(b) Connect using 3.5mm Jack cable
• TreadTracker has a 3.5mm jack input located at the front. If the Jack
cable is supplied with your TreadTracker, you may connect the sensor
directly to your mobile device that has the RunSocial App.
5. Naming Your TreadTracker Bluetooth Signal
• Once connected to TreadTracker via Bluetooth, you can customize your
Bluetooth signal name by clicking on the icon next to the Bluetooth name in
your RunSocial app.
NOTE:
RunSocial is evolving, check at
www.runsocial.com
for latest
Fig. 1
Summary of Contents for PFTK001
Page 1: ......
