CAMERA INSTALLATION
1.Loosen the license plate bolts/screws,
then remove the rear license plate.
2.Insert each license plate bolt into a
supplied wedge, then through the bolt
holes of the camera, then through the
remaining wedges and the license plate.
(Fig.1)
3.Align with holes on vehicle and
temporarily tighten the license plate
bolts/screws. The wedges will angle the
camera down.
4.You will need to choose a route for the camera's power cable through
the vehicle's body to the reverse light circuit.(Fig. 2)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
5.Some vehicle's may have a hole available
to pass the wire through, (Fig. 3) such as
where the license plate light is mounted,
or you can drill a hole close to where the
power cable is attached to the camera.
(Fig. 4) Once you have chosen where the
cable will enter the vehicle's body, remove
the camera. If you able to use an existing
opening, skip the next two steps.
6.If you are going to drill a hole, choose a
location as close to the camera where
the power cable comes out of it. BEFORE
YOU DRILL A HOLE YOU MUST CHECK
Using an Existing
Opening for Access
Drilling an Access Hole
-7-
When mounting the camera you must make sure that it's field of view
is not obstructed. To adjust the angle of the camera, use the supplied
wedge shaped shims. We recommend to attached the camera under the
license plate. The camera can be attached by screwing or sticking.
Summary of Contents for CC-105
