18
Fusion SKI
bathtub
EN
First run
HOW TO ACTIVATE FUNCTIONS
DISINFECTION
The disinfection function is an automatic cleaning
procedure for the bathtub's entire water circuit, including
the tanks. It should be carried out after every use of the
bathtub or after long periods of disuse.
HOW TO START IT
Press the "
disinfection
" key.
To prevent accidental use, after the first press the key
flashes blue. At this point:
A) If it is not pressed again, the key returns to fixed blue
and nothing happens (the system interprets the first
press as an accident).
B) If by the third blue flash the "
disinfection
" key is pressed
again, the function starts and the key turns solid red.
Subsequently:
- It is
filled
with water until the tank is completely filled
(SL3 sensor).
- The two pumps (whirlpool and recirculation) and the
solenoid valve of the
disinfectant
are activated for 30
seconds. The two pumps remain active for an additional
five minutes.
After five minutes the bathtub is automatically
drained
.
It is important to leave the bathtub switched on for at least
one hour after the end of the disinfection procedure to al-
low for the complete emptying of the pipes.
If the whirlpool is started but the water level in the minipool
is too low or there is no disinfectant in the reservoir, the key
will flash red three times and the cleaning will not start.
In this case fill the bathtub or top up the reservoir using the
appropriate products.
EMPTYING
Pressing the "
empty
" key activates the bathtub's automatic
emptying cycle.
To prevent accidental use, after the first press the "
empty
"
key flashes blue. At this point:
A) If it is not pressed again, the key returns to fixed blue
and nothing happens (the system interprets the first
press as an accident).
B) If by the third blue flash the key is pressed again, the
emptying cycle starts and the key changes from blue to:
-
Flashing red in the first phase of the cycle (it cannot be
interrupted).
-
fixed red in the second phase of the cycle (in this
moment it is possible to stop the emptying by pressing
the key again).
Throughout the entire emptying cycle, both chromatherapy
and the shower head can be activated.
It is important to leave the bathtub switched on for at least
one hour after the end of the disinfection procedure to al-
low for the complete emptying of the pipes.
x2
x2
DISINFECTANT