treesse
treesse
Pg. 12
?
DESCRIPTION OF PARTS
ACTIVE Mode
In
ACTIVE
mode, the spa is maintained under such conditions to be readily accessible to the user.
If there are no water level alarms, the recirculation pump is always active to filter the water.
When the control panel is turned on, it will be put in the same state at it was before the shutdown.
You can switch from
STANDBY
mode by pressing the two
UP
and
DOWN
scroll keys scroll
UP DOWN
.
STANDBY Mode
STANDBY
mode is used when it is expected that the spa will remain unused for a certain period of time
and keeps it at a temperature, selectable by the user, below the regular operating temperature of the
product.
The default value is 25°. In this state, the functions are disabled, and the recirculating pump, if there are
no water level alarms, is activated to maintain the temperature or to filter the water.
To enter and exit the
STANDBY
mode you must press the two
UP
and
DOWN
scroll keys.
The
STANDBY
mode is maintained even in the event of an outage and power surge.
When the spa is in
STANDBY
state, the display shows the message "
SBY
".
If the heater is running, the
LED
is active.
During the
STANDBY
mode, press the
UP
and
DOWN
keys to vary the temperature in
STANDBY
mode.
The minimum temperature can be set at 13 °C.
During the
STANDB
Y mode, for filtering and sanitizing are activated 2 times a day (every 12 hours)
both the pump and the ozonator.
During filtering, the
LED
is active.
Hydromassage
By pressing the HYDROMASSAGE key you will enable the function in
the spa.
The function is indicated by the HYDROMASSAGE LED that turns on.
This function can only be activated with the level of water at steady
operating values.
With EMPTYING active, the hydromassage is deactivated.
If not interrupted from the keyboard, it will turn off automatically after
20 minutes.
CONTROL PANEL
