3-3 Installing Nozzle Detect
WARNING:
Ensure air and power supply is off and disconnected
before proceeding. Please follow your facility's lockout / tagout
procedures.
NOTE:
This nozzle detect sensor has a sensing range of 5 mm and
can detect any metallic part that comes within this sensing range.
The accuracy is ± ≤2% (0.1 mm). The circuit is normally open until
the sensor detects a metallic part within its sensing range. The
green LED on the sensor will always be on if there is power to the
reamer.
A. Mounting Nozzle Detect
1. Using two (2) M3x0.5x16 mm SHCS, attach the nozzle detect
to the side of the clamp housing in the two threaded
holes. Torque to 8-10 in-lbs.
2. Connect the supplied 4 Pin cable to the sensor and wire back
to PLC / Robot Controller for monitoring.
Figure 3-F
12
OM-TT3-1.4
