READ INSTRUCTIONS.
l
Read and follow all labels and the Owner's
Manual carefully before installing, operating,
or servicing unit. Read the safety information
at the beginning of the Manual and in each section.
l
Use only genuine replacement parts from the manufacturer.
l
Perform installation, maintenance, and service according to
the Owner's Manuals, industry standards, and national,
state, and local codes.
H.F. RADIATION can cause interference.
l
High-frequency (H.F.) can interfere with radio
navigation, safety services, computers, and
communications equipment.
l
Have only qualified persons familiar with electronic
equipment perform this installation.
l
The user is responsible for having a qualified electrician
promptly correct any interference problem resulting from the
installation.
l
If notified by the FCC about interference, stop using the
equipment at once.
l
Have the installation regularly checked and maintained.
l
Keep high-frequency source doors and panels tightly shut,
keep spark gaps at correct setting, and use grounding and
shielding to minimize the possibility of interference.
ARC WELDING can cause interference.
l
Electromagnetic energy can interfere with
sensitive electronic equipment such as
computers and computer-driven equipment
such as robots.
l
Be sure all equipment in the welding area is
electromagnetically compatible.
l
To reduce possible interference, keep weld cables as short
as possible, close together, and down low, such as on the
floor.
l
Locate welding operation 100 meters from any sensitive
electronic equipment.
l
Be sure the welding machine is installed and grounded
according to the Manual.
l
If interference still occurs, the user must take extra measures
such as moving the welding machine, using shielded cables,
using line filters, or shielding the work area.
OM-TT3-1.4
5
