Instructions for Use and Maintenance 2452H (1402)
trejonindustries.se
12
12
Breddningsving
en monteras
på insidan av
maskinen
Safety during maintenance and repairing.
Apply hand brake and place the machine on a
hard level surface when maintaining or adjusting it. Always stop the tractor, set brake, shut off
the tractor engine, remove the ignition key, and allow machines moving parts to come to a
complete stop before dismounting tractor. Ensure that all moving parts have stopped completely
before making adjustments, servicing or cleaning the machine. If the machine has been raised
for cleaning, maintenance, inspection or repairs, it is imperative that you prevent it from sinking
or falling down by placing supports under the machine. Never work under equipment unless it is
blocked securely. Keep service area clean and dry. After servicing, be sure all tools, parts and
service equipment are removed. Clean the machine thoroughly before repairs or storage. Be
sure to thoroughly wash the machine without using excessive pressure especially on the moving
parts, bearings and electric components. After cleaning, carefully dry the machine and lubricate
it and perform a short test drive.
Vibrations.
Do not use the machine if it is vibrating or shaking. Stop and investigate the cause.
Change any damaged parts.
Emergency stop.
Know how to stop the tractor and machine quickly in case of an emergency.
After striking an obstacle, shut the tractor down and thoroughly inspect for damage before
restarting.
Hydraulic hoses.
The machine’s hydraulic hoses contain oil under high pressure. Never
touch the hoses or other hydraulic components while there is still pressure in the system. In
case of leakage, oil under high pressure can penetrate the skin and cause serious injuries. If
accident happen, contact doctor.
Check the condition of the hydraulic hoses every day. Worn or leaking hoses must be replaced
immediately with new hoses that meet the manufacturer’s technical requirements.
The hydraulic motor and the hoses become hot during work; there is a risk for burn injury.
Never loosen the hoses while the oil is still hot. Wait until it cools down. When changing tractor,
check length of hydraulic hoses, if to long or short, they can easily be damaged.
The hydraulic motor and the hoses become hot during work; there is a risk for burn injury.
Never loosen the hoses while the oil is still hot. Wait until it cools down.
Welding.
Protect bearings, electronic and hydraulic components before any welding is done.
Place earth connection close to the place for welding.
Fire danger.
If any component gets over heated, stop machine and check reason. There is an
increased risk of fire when working in dry areas.
Spare parts.
Use only original repair parts
Where replacement parts are necessary for periodic maintenance and servicing, genuine
replacement parts must be used to restore your equipment to original specifications. The
company will not claim responsibility for use of unapproved parts and/or accessories and other
damages as a result of their use.
Unauthorized modifications to the machine may impair the function and/or safety of the machine
and reduce its life. If equipment has been altered in any way from original design, the
manufacturer does not accept any liability for injury or warranty.
