Instructions for Use and Maintenance 2452H (1402)
trejonindustries.se
19
19
Breddningsving
en monteras
på insidan av
maskinen
Support pads
The height of the equipment is adjusted with two supporting pads located at the back. The
angle of the equipment is adjusted by the tilt fu
nction of the tractor’s loader. This determines the
how well the equipment follows the variations in the surface. If the equipment is angled forward,
it is easier for it to cut through packed snow and ice. A suitable basic adjustment when the
machine rest on the support pads, is that the wearing edge of the scraper steel is 10mm above
ground. Aim at keeping the machine levelled during work.
The supporting pads are to be adjusted as the wearing edge is being worn down. The
supporting pads are adjusted by undoing the mounting screws, and mount them in other holes.
Ejector tube
The equipment comes fitted with a hydraulically turntable ejector tube as standard. At the end of
the tube is a flap that regulates the distance the snow is thrown. Turn up the handle that locks
the pierced rod, move the rod to the desired position and lock it again.
A hydraulically (or electrically) operated flap is available as an option. This is suitable for those
that need to change the placing of the ejected snow while operating the equipment.
Mechanical flap control (Standard)
Hydraulic flap control (Option)
Locking handle
for mechanical
flap control.
Fixing bolts for supporting pads. Can
be adjusted for various heights.
