Instructions for Use and Maintenance 2452H (1402)
trejonindustries.se
22
22
Breddningsving
en monteras
på insidan av
maskinen
4 Service and maintenance
Warning!
Always turn off the engine and wait until the machine has completely stopped before
performing any kind of service or maintenance on the machine. Remove the ignition key
from the ignition switch.
Relieve the pressure before operating the implement. Let the machine cool down
if warm.
Never use the tractor’s lifting scoop alone. Secure the implement with jack stands or
similar devices in order to avoid falling. Always use protective glasses, gloves etc. when
performing maintenance.
Do not use your fingers when examining little openings. This is to avoid accidents.
Keep work area clear of other persons in order to avoid injuries.
4.1 General information
Always use high quality lubricants. If work is to be performed on the implement while it is in high
position, don’t forget to secure it with stand jacks. Use only tools fitted to their purpose. Keep
the machine clean in order to prevent corrosion and maintain a good working condition.
Lubricate the machine immediately after cleaning it with water.
Use the table below for the correct torque settings for the screws and bolts of the machine.
Table 1
– Tightening torque of screw joint reinforcement
Diameter
Class 8.8
Class 10.9
Nm
lb.ft.
Nm
lb.ft.
M8
M10
M12
M14
M16
M18
M20
25
50
90
140
215
295
420
18
37
66
103
155
217
302
35
70
125
200
305
420
590
26
52
92
148
225
309
438
Increase the torque by 5% when using a locknut.
